3 Series E46 320d (M47) TOUR
32 41 060
Removing and installing power steering vane
pump (M47)
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off pipe connections with plugs.
Necessary preliminary tasks:
•
Draw off and dispose off hydraulic fluid from fluid reservoir
Observe country-specific waste-disposal regulations
•
Slacken drive belt and remove from belt pulley
•
Remove panel for engine on left (refer to "Removing and
installing air intake manifold")
Disconnect cooler return line (1) from fluid reservoir.
Disconnect pressure line (2) from vane pump.
Installation:
Replace sealing ring.
Tightening torque 32 41 3AZ
.
Remove pulley.
Unfasten screws.
RA Removing and installing power steering vane pump (M47)
BMW AG - TIS
12.02.2013 17:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
