3 Series E46 320d (M47) TOUR
51 13 319
Removing and installing/replacing trim strip
on drip moulding on rear left or right
(Touring)
Partially detach trim strip on drip moulding (do not remove),
refer to 51 13 316.
Note:
Make sure body is not damaged in area of A- and C-pillars.
Trim strip (1) is removed with special tool 00 9 318 (universal
wedge).
-
Starting in area of D-pillar, clip out trim strip (1) towards C-
pillar,
-
clip out centering (2) and remove trim strip (1).
Installation:
To prevent leaks and noises:
Check all clips for visible damage.
Following components must not be damaged, replace if
necessary:
1.
Retainer
2.
Seal
3.
Plastic carrier
4.
Grommet
To assist installation of trim strip, it is necessary to moisten
seal (5) of side window with water.
Following components of trim strip (5) must not be damaged,
replace if necessary:
1.
Guide
2.
Clip
3.
Seal
4.
Support
RA Removing and installing/replacing trim strip on drip moulding on rear left or ri
BMW AG - TIS
12.02.2013 20:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -