3 Series E46 320d (M47TU) SAL
-
Remove propeller shaft from transmission.
-
Release center bearing.
-
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
Note:
When removing and installing the transmission, support the front
end of the engine at the housing with an installation aid
(e.g. transmission lifter).
Lever out retainer (1).
Disengage shift rod (2).
Installation:
Grease shift rod.
Grease,
Refer to BMW Service Operating Fluids.
Make sure shims (3) are in correct position.
Release and remove bearing pins (1) in direction of arrow.
Lift out shift arm (1).
Installation:
Grease bearing pins (1).
Grease,
Refer to BMW Service Operating Fluids.
RA Removing and installing transmission (GS6-37BZ/DZ)
BMW AG - TIS
12.02.2013 15:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -