3 Series E46 320d (M47TU) SAL
31 11 001
Replacing front axle carrier
Necessary preliminary tasks:
•
Secure engine in installation position
•
Remove underbody protective plate
•
Remove reinforcement/reinforcement plate
•
If necessary, remove ride-height sensor with bracket from
front axle carrier
•
Remove both brackets for control arm from engine carrier
•
Remove control arm from front axle carrier
•
Remove power steering gear from front axle carrier and tie up
After installation:
•
Perform chassis alignment check
•
Carry out steering angle sensor adjustment
Support front axle carrier, release from engine carrier and carefully
lower.
Remove engine mounts on both sides, if necessary with vacuum
line from front axle carrier.
Take front axle carrier down and set down on a suitable surface.
RA Replacing front axle carrier
BMW AG - TIS
12.02.2013 16:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -