3 Series E46 320d (M47TU) SAL
Replace bushing (1) and crash sleeve (2).
Unscrew nut (1).
Remove screw (3) with washer (2).
Installation:
Screw must fit in both guide bushes.
Coat nut (1) with Loctite and tighten down.
Tightening torque 32 31 8AZ
.
Installation:
Observe guide bushes.
Pull down steering column.
Press down both locking hooks.
Detach steering angle sensor.
Press down locking hooks.
Remove locking element.
RA Removing and installing/replacing steering angle sensor
BMW AG - TIS
12.02.2013 17:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -