3 Series E46 320d (M47TU) SAL
32 34 020
Removing and installing/replacing airbag unit
Warning!
Observe the following instructions to avoid any risk of injury by
the airbag unit.
-
Comply with safety regulations for handling components
with gas generators.
-
Do not exert any force on the airbag unit.
-
Use only specified tools for releasing the airbag unit.
Note: Incorrect handling may result in triggering of the airbag
unit and thereby cause serious injury.
Important!
Steering wheel must be replaced if airbag unit has been
triggered!
Follow procedure after airbag triggering.
Necessary preliminary tasks:
•
Disconnect battery negative lead
Release screws (Torx T30) on both sides.
Installation:
Make sure electrical leads are correctly positioned.
Tightening torque 32 34 1AZ
.
RA Removing and installing/replacing airbag unit
BMW AG - TIS
12.02.2013 17:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -