3 Series E46 320d (M47TU) SAL
33 32 160
Removing and installing / replacing tension
strut for rear axle carrier
Necessary preliminary tasks:
•
M3:
-
Remove strut
-
Remove intermediate pipe with catalytic converter
•
Remove panel from fuel tank
Release screws and remove heat shield.
Support rear axle carrier at front middle with workshop jack.
Release screws (2).
Tightening torque 33 32 17AZ
.
Release nuts (1) and remove tension strut.
Installation:
Replace self-locking nuts.
Tightening torque 33 33 3AZ
.
RA Removing and installing / replacing tension strut for rear axle carrier
BMW AG - TIS
12.02.2013 18:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -