3 Series E46 320d (M47TU) SAL
Mark out and cut separating point at carrier support on right.
A = approx. 120 mm from edge of carrier support.
B = approx. 15 mm from bore
∅
7 mm.
Drill out welding spots of partial replacement carrier support.
Remove partial replacement carrier support on right.
Caution!
Do not damage engine support reinforcement when removing
remaining metal.
Remove remaining metal, engine support front section.
For this purpose, cut open welding spots with a chisel between
engine support reinforcement (2) and engine support front section
(1).
RA Replacing engine support front section on right
BMW AG - TIS
12.02.2013 20:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -