3 Series E46 320d (M47TU) SAL
Installation:
To avoid leaks and noises, check all clips (2) for visible
damage.
Loose or damaged clips (2), as shown in illustration, must be
replaced as follows:
- Knock through split pin (1) with split pin driver and hammer,
- split pin (1) is allowed to drop into inside of side frame,
- remove clip(s) (2) by hand.
Installation:
Seal (1) on clip (2) must not be missing (leakage).
- Insert clip (2) in bore,
- press in split pin (3) until flush with clip (2), do not knock in
(risk of damage, denting).
Coat area (A) of C-pillar with soapy solution.
Note:
Be sparing with soapy solution on account of contamination
and risk of accident (risk of slipping if spilled etc.).
Attach protective strip (1) at height of breastwork (2).
Caution!
- Carry trim strip in middle only (risk of damage),
- carry out installation with two persons,
- prepositioning of trim strip,
- ensure gutter runs parallel to side frame (risk of breakage).
RA Removing and installing/replacing trim strip on roof gutter at left or right
BMW AG - TIS
12.02.2013 20:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -