3 Series E46 320d (M47TU) TOUR
12 61 280
Removing and installing/replacing oil
pressure switch (M47TU / M47T2)
Note:
Drain the full flow oil filter to prevent excessive oil discharge when
removing the oil pressure switch.
Important!
When working on the oil, coolant or fuel circuit, you must
protect the alternator against contamination.
Cover alternator with suitable materials.
Failure to comply with this procedure may result in an
alternator malfunction.
Important!
Do not damage oil-filter cover.
Release and tighten down with a socket only.
When the main flow oil-filter cover is released, the oil flows
from the oil-filter housing back into the sump.
Release oil-filter cover and remove towards top.
Tightening torque 11 42 2AZ
.
Installation:
Replace sealing rings and coat with oil.
RA Removing and installing/replacing oil pressure switch (M47TU / M47T2)
BMW AG - TIS
12.02.2013 14:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -