3 Series E46 320d (M47TU) TOUR
32 31 082
Removing and installing/replacing steering
angle sensor
Special tools required:
•
32 3 040
Necessary preliminary tasks:
•
Remove lower section of steering spindle
•
Remove trim panel for pedal assembly
After installation:
•
Replacement only: Carry out programming/coding
•
Carry out steering angle sensor adjustment
Push steering spindle upper section into steering column.
Note:
For purposes of clarity, the following work steps are shown on a
steering column which has been removed.
Press crash disk (3) off crash sleeve (2).
Lift crash sleeve (2) out of groove of steering spindle upper
section.
Push steering spindle upper section into steering column.
Remove crash disk (3), crash sleeve (2) and bushing (1).
Installation:
RA Removing and installing/replacing steering angle sensor
BMW AG - TIS
12.02.2013 17:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -