3 Series E46 320d (M47TU) TOUR
Release retaining screw, A-pillar.
Note:
Screw is held in end fitting by locking washer.
Installation:
Tightening torque,
refer to Technical Data 72 12 4AZ
View of mounting bolt on A-pillar with end fitting of ITS head
airbag
1.
End fitting of ITS head airbag
2.
Lock washer
3.
Mounting bolt on A-pillar
Release rear retaining screw (1).
Note:
Bolt is held in end fitting (2) by retaining disk.
Installation:
Tightening torque,
refer to Technical Data 72 12 4AZ
View of rear retaining screw with end fitting of ITS head airbag
1.
End fitting of ITS head airbag
2.
Lock washer
3.
Retaining screw, rear
RA Removing and installing / replacing left or right ITS head airbag (model without
BMW AG - TIS
13.02.2013 03:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 14 -