3 Series E46 320i (M54) TOUR
32 21 231
Replacing left or right tie rod
Necessary preliminary tasks:
•
Remove tie rod end from swivel bearing
•
Remove gaiter from power steering gear and slide back
After installation:
•
Perform chassis alignment check
•
Carry out steering angle sensor adjustment
Important!
To avoid damage to rack and to suspension mounting, move
rack in as far as possible.
Screw tie rod off rack of power steering gear (WAF 34).
Tightening torque 32 21 2AZ
.
Determine measurement (A) to simplify following adjustment of
front axle.
Release clamping nut.
Screw off tie rod end; if necessary, grip tie rod with open-end
wrench.
Installation:
Use a new gaiter.
Mount clamping ring (1).
Screw in tie rod end to measurement (A).
Tightening torque 32 21 5AZ
.
RA Replacing left or right tie rod
BMW AG - TIS
13.02.2013 09:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -