3 Series E46 320td (M47TU) COMP
Remove holder for glow control unit (two screws on right side).
Disconnect positive lead (1) and both control lines (2 and 3) on
starter.
Installation:
Tightening torque, 12 41 4AZ
Detach positive lead (2) of auxiliary heater from solenoid switch
on starter motor.
Detach battery positive lead (3) from solenoid switch on starter
motor.
Note:
Illustration similar.
Illustration shows starter motor on removed engine.
Loosen screws (2).
(For accessibility reasons, use extensions and joint.)
Note:
Illustration similar.
Withdraw starter motor (1) from transmission flange and tilt out
past engine carrier.
Installation:
Tightening torque, 12 41 1AZ
RA Removing and installing/replacing starter motor (M47TU)
BMW AG - TIS
13.02.2013 05:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
