3 Series E46 325Ci (M54) COUPE
Turn the eccentric shaft to tension the bearing caps.
Unfasten nuts on bearing cover.
Relieve tension on eccentric shaft and remove special tool
11 3 260 .
Remove bearing covers and place to one side in orderly fashion.
Remove camshaft.
Note:
If the cylinder head is then to be removed, remove complete
bearing strip with bucket tappets.
Locate bucket tappets in bearing strip with special tool
11 3 250 .
Lift out complete bearing strip with bucket tappet.
Note:
Only re-use used bucket tappets in the same tappet bore.
Check bearing points on bucket tappets for signs of wear
(scoring).
RA Replacing camshaft (M52TU / M54 / M56)
BMW AG - TIS
17.02.2013 13:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -