3 Series E46 325Ci (M54) COUPE
Unfasten nut.
Pull out screw.
Remove bearing block towards top.
Installation:
Replace self-locking nut.
Tightening torque 33 32 12AZ
.
Installation with special tool:
Installation:
Secure special tool 33 3 280 to bearing pedestal with a screw
and align to wheel center. Place bearing block in position and
screw down.
Tightening torque 33 32 12AZ
.
Installation without special tool:
Installation:
Place tube (1) (length = approx. 500 mm, dia. = 16 mm) flat on
bearing block, secure with screw clamp and align tube center to
wheel center. Screw bearing pedestal down in this position.
Tightening torque 33 32 12AZ
.
After installation:
•
Perform chassis alignment check
RA Replacing bearing block for front trailing arm
BMW AG - TIS
17.02.2013 18:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -