3 Series E46 325Ci (M54) COUPE
Detach retainer and disconnect piston rod.
Installation:
Use new retainer.
The retainer must be seated with both legs in the pin groove.
The workshop supervisor must mark the retainer with a dot of
red paint (1) thereby acknowledging correct installation.
Disconnect return spring.
Detach retainer (1) and pull brake pedal off bearing block. If
necessary, tilt panel (2) upwards.
Installation:
Attach new retainer (1).
Installation:
Check bearing bushes (1) and replace if necessary.
Lightly grease bearing bushes (1),
Brake pedal with retaining bracket
Detach retainers (1).
Installation:
Use new retainers (1).
RA Removing and installing/replacing brake pedal
BMW AG - TIS
17.02.2013 19:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -