3 Series E46 325Ci (M56) COUPE
12 61 280
Removing and installing/replacing oil
pressure switch (M52TU, M54, M56)
Switch off ignition.
Remove suction filter housing.
Unfasten oil filter cover to enable engine oil in filter to flow back
into the oil sump.
The procedure is described in the section BMW engine oil
service.
Location: On base of oil-filter.
Note:
Figure shows power steering pump supply tank removed.
Disconnect plug connection (2).
Caution!
A few drops of oil escape when the oil pressure switch is
released. Catch residual oil with cleaning cloth and dispose of
oil.
Release oil pressure switch.
Installation:
Tightening torque, 12 61 1AZ
.
RA Removing and installing/replacing oil pressure switch (M52TU, M54, M56)
BMW AG - TIS
13.02.2013 21:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -