3 Series E46 325i (M54) SAL
Lay seal (1) without stretching as follows and vertically press down
hard to adhesive area:
-
Next to door seam approx. 1.5 mm
-
Edge of adhesive tape just covering
-
If necessary, edges of positioning aids just covering
Caution!
It is not the time spent pressing, but rather the pressure head
(approx. 10 ... 15 N/cm
2
) that is decisive.
Separation of seal after pressing destroys the adhesive layer.
Profile rubber adhesive must be reapplied.
Caution!
Keep adhesive cleaner away from repaired adhesive area of
seal.
Note:
Scrape off visible profile rubber adhesive with special tool
00 9 322 (plastic wedge).
If necessary, use adhesive cleaner (sourcing reference: BMW
Parts Service).
Remove adhesive tape (if necessary positioning aids) and
assemble rear door.
RA Attaching seal on front and rear doors, left or right
BMW AG - TIS
17.02.2013 17:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -