3 Series E46 325i (M54) TOUR
12 51 001
Replacing wiring harness section for engine
(M54)
Interrogate fault memory of DME control unit.
Switch off ignition.
Follow instructions for disconnecting and connecting battery.
Disconnect battery negative lead from battery.
Warning!
Scalding hazard!
Only perform these tasks on an engine that has cooled down.
E53 and E46:
Remove reinforcement plate.
Caution!
The section "Removing and installing reinforcement plate"
contains important installation instructions.
Remove underbody protection.
E53, E46, E39:
Detach plug (1) from oil level sensor.
Unclip cable from cable holder (2) and lay upwards.
RA Replacing wiring harness section for engine (M54)
BMW AG - TIS
13.02.2013 23:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -