3 Series E46 325i (M54) TOUR
Installation:
Greasing specification:
-
Remove and clean release bearing and release lever.
-
Push on grease scraper ring 21 2 221 as far as it will go.
-
Grease splines (1) of input shaft with a brush. Refer to BMW
Service Operating Fluids.
-
Detach grease scraper ring.
Important!
After completing work:
-
Perform adaptation using DIS Tester, refer to Service
Functions in DIS Tester (Teach in transmission)
-
Check transmission oil level
Use only the approved transmission oil
-
Check fluid level in hydraulic system
-
Read out fault memory and clear entered faults
Failure to comply with this requirement will result in serious
damage to the manual transmission.
RA Removing and installing transmission (GS6S37BZ SMG)
BMW AG - TIS
14.02.2013 01:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -