3 Series E46 325i (M54) TOUR
Remove heat shield (1) from valve block.
Remove exhaust mounting (1).
Support transmission with a workshop hoist.
Release screws and remove cross-member (2).
Tightening torque, 23 71 1AZ / 2AZ
.
Release screws.
Tightening torque, 26 11 1AZ .
Installation:
Replace self-locking nuts.
Grip propeller shaft and release nuts.
Tightening torque 26 11 6AZ .
Bend propeller shaft downwards at center bearing (1).
Detach propeller shaft from transmission output flange and tie
back to side on vehicle underbody.
RA Removing and installing transmission GS5S31BZ (SMG)
BMW AG - TIS
14.02.2013 01:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -