3 Series E46 325i (M54) TOUR
23 42 510
Replacing pressure sensor GS5S31BZ (SMG)
Note:
After completing work:
Proceed according to test program.
refer to "Service Functions" in DIS Tester.
Check fluid level in hydraulic system.
Important!
Depressurize hydraulic system.
Proceed according to "Service Functions" in DIS Tester.
Remove heater bulkhead.
Remove heat shield from valve block.
Remove complete exhaust system.
Release center bearing on propeller shaft. Release transmission
at cross-member and lower. The procedure and the tightening
torques are described in the section "Removing and installing
transmission".
Disconnect plug connection (1).
RA Replacing pressure sensor GS5S31BZ (SMG)
BMW AG - TIS
14.02.2013 01:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -