3 Series E46 325i (M54) TOUR
Installation:
During installation: do not damage radial shaft seal and bearing.
If the torque converter is not correctly installed, the driver of the
pump impeller may be damaged when the transmission is flanged
to the engine.
Remove torque converter and set down vertically.
Replace sealing ring (1).
Push torque converter through radial shaft seal onto transmission
shaft as far as it will go.
Press torque converter by hand into converter housing and rotate
in so doing. Converter hub opening must snap into place in driver
of pump impeller. Torque converter must be felt to slip inwards.
Calculate measurement between contact face and area (1) of
tapped hole of torque converter with special tool 00 2 550 .
Torque converter is correctly installed when measured value is
greater than 30 mm.
RA Removing and installing/replacing torque converter (A5S 360R / 390R, A4S 200R)
BMW AG - TIS
14.02.2013 02:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -