3 Series E46 325i (M54) TOUR
Important!
Do not under any circumstances tighten down collar nut
beyond marker points in order to avoid damaging the
clamping sleeve.
Tighten down collar nut (1) to point where marker points are
aligned.
Drive in new retaining plate with following special tools (depending
on rear differential) as far as it will go.
-
168K, 188K: Use special tools 00 5 500 and 33 3 480
-
210N, 215K, 220K: Use special tools 00 5 500 and
33 3 490
After installation:
•
Change rear differential oil
RA Replacing shaft seal for input flange on final drive
BMW AG - TIS
14.02.2013 04:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -