3 Series E46 325i (M54) TOUR
34 52 515
Removing and installing/replacing control
unit for ABS/ASC+T
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Before starting work, read out fault memory of ABS/ASC+T control
unit and print out diagnostic record.
Remove and install ABS/ASC+T unit,
Refer to 34 51 525
To remove the ABS/ASC+T unit, seal the line connections with the
plugs provided in the repair kit. This prevents brake fluid from
being discharged from the hydraulic unit, which in turn makes it
easier to bleed the brake system later.
Release screws (1) and carefully detach control unit (2) from
hydraulic unit (3).
Installation:
Replace micro-encapsulated screws.
Note tightening torque,
Refer to 34 51 1AZ .
RA Removing and installing/replacing control unit for ABS/ASC+T
BMW AG - TIS
14.02.2013 09:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -