3 Series E46 325i (M54) TOUR
Installation:
-
Seal (1) on clip (2) must not be missing
(leaks).
-
Insert clip (2) into bore
-
Press in split pin (3) until flush with clip (2), do not drive
in (risk of damage, denting)
Caution!
-
Only carry trim strip by its middle (risk of damage)
-
Carry out installation with two persons
-
Prepositioning of trim strip
-
Ensure drip moulding runs parallel to side frame (risk of
breakage).
Installation:
Installation of trim strip (1) on clips:
-
Do not drive in trim strip (1), this would create risk of damage
and produce denting.
-
Fit trim strip (1) at rear (A) and clip onto rear trim strip.
-
Position from rear (A) to front (B) and clip into place (audible
click).
-
Position from bottom (C) to top (B) and clip into place
(audible click).
RA Removing and installing/replacing trim strip on drip moulding on left or right (
BMW AG - TIS
14.02.2013 11:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -