3 Series E46 325i (M54) TOUR
72 11 030
Removing and installing/replacing front seat
belt
Caution!
Note safety regulations for handling airbag modules and
pyrotechnical seat belt tensioners,
refer to MG 72
Inexpert handling can trigger off the airbag or the belt
tensioner and thus cause injury.
The plug connections for the pyrotechnical seat belt
tensioners are no longer marked "Orange"!
To remove and install the seat belt, it is necessary to remove and
install the front seat.
Remove panel for door pillar (top),
refer to 51 43 148.
If the pyrotechnical seat belt tensioner is removed and installed or
replaced, the front seat must be removed and installed.
Remove and install left or right front seat,
refer to Group 52.
Note:
If a seat belt which is damaged due to an accident is
exchanged, always check the seat belt retaining bracket on
the seat runner for damage (bending) and replace if
necessary.
A bent seatbelt tensioner retaining bracket on the seat runner may
make it impossible to adjust the height of the seat!
Unscrew bracket.
To do so, release both screws.
RA Removing and installing/replacing front seat belt
BMW AG - TIS
14.02.2013 17:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -