3 Series E46 325xi (M54) SAL
•
Remove cross-member.
If fitted:
Remove vacuum reservoir for exhaust flap.
Unclip fuel line (1) from holders (2).
Note:
For a better overview, this work step is shown on an engine that
has been removed.
Unlock plug (1) of crankshaft pulse generator and disconnect.
Release nut (1) and disconnect battery positive leads from starter
motor.
Installation:
Tightening torque, 12 41 4AZ
.
Release nuts (1).
Installation:
Tightening torque, 12 41 4AZ
.
Remove lines (2) from starter motor.
RA Removing and installing/replacing starter motor (M54 4WD)
BMW AG - TIS
14.02.2013 09:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
