3 Series E46 330d (M57) TOUR
Detach sealing strip (1).
Pull out profile seal (2).
Release screw (3).
Pull out profile seals (4 and 5).
Installation:
To prevent leaks, you must install profile seals correctly.
Release screws (1) and remove cover from electronics box.
Installation:
Tightening torque,
refer to Technical Data 12 90 4AZ.
Pull profile seals (1) out of electronics box.
Installation:
To prevent leaks, you must install profile seals correctly.
Disconnect plug (1) on DDE control unit.
RA Replacing wiring harness section for engine (M57)
BMW AG - TIS
15.02.2013 11:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -
