3 Series E46 330d (M57) TOUR
Detach sealing strip (1).
Pull out profile seal (2).
Installation:
To prevent leaks, you must install profile seals correctly.
Release screws (1).
Remove cover from electronics box.
Installation:
Tightening Torque,
refer to Technical Data 12 90 4AZ.
Disconnect plug (1) on DDE control unit.
Pull profile seal (2) of wiring harness out of electronics box.
Installation:
To prevent leaks, you must install profile seals correctly.
Remove wiring harness section for injectors.
Note:
Read out fault memory of DDE control unit (DDE = Digital
Diesel Electronics).
Check stored fault messages.
Rectify faults.
Now clear the fault memory.
RA Replacing wiring harness section for injectors (M57)
BMW AG - TIS
15.02.2013 11:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
