3 Series E46 330d (M57) TOUR
Brace output flange with special tool 23 0 020 .
Release collar nut (1) with special tool 23 0 200 .
Tightening torque: 23 21 1AZ
.
Installation:
Insert collar nut (1) with Loctite 243.
Loctite 243: BMW Parts Service.
Detach output flange with 3-claw extractor from output shaft.
Installation:
Heat output flange to approx. 80
°
C and push onto output
shaft.
Remove radial seal with special tool 00 5 010 .
Coat sealing lips of new radial seal (1) with transmission oil.
Drive in radial seal (1) with special tool 23 0 190 and plastic
hammer until flush.
RA Replacing radial seal for output flange (GS5-39DZ)
BMW AG - TIS
15.02.2013 12:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -