3 Series E46 330xd (M57) TOUR
If necessary, replace connecting rods.
The BMW Parts Service only supplies connecting rods in
complete sets.
Note:
It should be possible to press piston pin into bush by hand
using only slight pressure. Clearance should then be minimal.
Replace conrod bearing shells,
refer to 11 24 571.
Fit the connecting rod to the piston in such a way that, when the
pair number is visible, the installation arrow on the piston points to
the right.
Caution!
Piston and piston pin are matched to each other.
They must not be mixed up.
Fit the retaining ring with its aperture opposite to recess.
Caution!
Re-install piston, connecting rod and bearing shells back in
the same position and in the same installation location.
Connecting rods and bearing covers are designated with the
same pair number: do not mix them.
RA Removing and installing / replacing all pistons (M57)
BMW AG - TIS
15.02.2013 21:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
