bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

12 RA Replacing Pressure Regulator On High-pressure Pump (M57)|Page 879 > < 11 RA Removing And Installing_replacing Pressure Sensor On Pressure Accumulator Of Inj
Page 1
background image

13 53 570

Replacing pressure regulator on high-
pressure pump (M57)

Read out fault memory of DDE control unit. Turn off
ignition.

Caution!

When working on the oil, coolant or fuel circuit, you must
protect the alternator against contamination.

Cover alternator with suitable materials.

Failure to comply with this procedure may result in an
alternator malfunction.

Recycling:

Catch and dispose of escaping fuel.

Observe country-specific waste-disposal regulations.

Arrangement of Common Rail System (M57),

refer to MG13 53 ...

Remove and install intake air manifold,

refer to 11 61 050.

RA  Replacing pressure regulator on high-pressure pump (M57)

BMW AG - TIS

15.02.2013  22:20

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

12 RA Replacing Pressure Regulator On High-pressure Pump (M57)|Page 879 > < 11 RA Removing And Installing_replacing Pressure Sensor On Pressure Accumulator Of Inj