3 Series E46 330xd (M57) TOUR
Screw special tool 13 5 192 into timing case cover at front.
Screw special tool 13 5 191 without forcing screw (1) into chain
wheel of H.P. pump.
Then insert forcing screw (1) until contact is made.
Tighten forcing screw (1) until H.P. pump is released from chain
wheel.
Remove H.P. pump.
Caution!
The special tool 13 5 190 must remain in the vehicle to
secure the chain wheel and must not be removed under any
circumstances!
Remove forcing screw (1) to install H.P. pump.
Installation:
•
Replace seal (1).
•
Note position of seal (1).
•
Sealing faces must be dry and grease-free.
RA Removing and installing/replacing high-pressure pump (M57)
BMW AG - TIS
15.02.2013 22:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
