3 Series E46 330xd (M57) TOUR
31 31 000
Removing and installing complete front left or
right spring strut (4WD)
Important!
If the centering pin is missing from the support bearing, the
position of the studs to the wheel arch must be marked so that
the original camber is approximately maintained.
Only one nut may ever be released for marking.
After installation:
•
Carry out wheel alignment check if a spring strut with support
bearing has been installed without centering pin.
Necessary preliminary tasks:
•
Remove swivel bearing
Centering pin missing: Make position of studs in relation to wheel
arch.
Secure spring strut against falling out.
Unscrew nuts.
Remove spring strut downwards out of wheel arch.
Installation:
Align spring strut using centering pin (1) to bore (2) in wheel
arch or studs to wheel arch and push upwards.
Replace self-locking nuts.
Tighten nuts.
Tightening torque 31 31 1AZ
.
RA Removing and installing complete front left or right spring strut (4WD)
BMW AG - TIS
16.02.2013 00:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -