3 Series E46 330xi (M54) SAL
Remove exhaust system.
Remove heat shield in middle.
Remove and install front propeller shaft.
Release screws and remove exhaust bracket (1).
Release screws.
Tightening torque, 26 11 1AZ.
Installation:
Replace self-locking nuts.
When tightening screws down: Grip each screw and tighten
down nut. This prevents the flexible disk from being subjected
to torsion stress.
RA Removing and installing transmission (S5D 320Z, 4WD)
BMW AG - TIS
16.02.2013 09:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
