3 Series E46 330xi (M54) SAL
Detach retaining clip (1).
Withdraw selector rod (2) from joint and remove washers (3).
Installation:
Grease selector rod.
Grease,
refer to BMW Service Operating Fluids.
Pay attention to installation position of washers (3).
Lever out spring (1) with a screwdriver from lug (2) on housing.
Tilt spring upwards.
Remove bearing pin (1).
Installation:
Grease bearing pin (1).
Grease,
refer to BMW Service Operating Fluids.
Unfasten steering spindle from steering gear. This operation is
described in the section "Removing and installing power steering".
RA Removing and installing transmission (S5D 320Z, 4WD)
BMW AG - TIS
16.02.2013 09:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -