3 Series E46 330xi (M54) SAL
Unfasten screws.
Installation:
Replace self-locking nuts.
Tightening torque, 26 11 1AZ.
Caution!
Do not let propeller shaft fall into joints.
Joints and rubber sleeve can be damaged on constant-velocity
joint.
Grip propeller shaft.
Unscrew nuts.
Tightening torque, 26 11 6AZ.
Bend propeller shaft downwards at center bearing (1).
Detach propeller shaft from transmission output flange and tie
back to side on vehicle underbody.
Installation:
Pull off cover tape from butylene tape on both sides.
Stick butylene tape (1) to outside of center bearing (2).
Butylene tape,
refer to BMW Parts Service.
RA Removing and installing automatic transmission (A5S 360R / 390R, 4WD, M54)
BMW AG - TIS
16.02.2013 09:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -