3 Series E46 330xi (M54) SAL
-
Remove propeller shaft from transmission.
-
Release center bearing.
-
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
Lift off retainer (1).
Remove disk (3).
Remove selector rod (2).
Installation:
Grease selector rod pin.
Grease,
refer to BMW Service Operating Fluids.
Insert special tool 25 1 110 in mounting.
Turn special tool 25 1 110 90
°
counterclockwise.
Press mounting upwards out of selector arm.
Pull rubber gaiter out of body aperture and remove with selector
lever.
RA Removing and installing selector lever (AWD)
BMW AG - TIS
16.02.2013 10:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
