3 Series E46 330xi (M54) SAL
32 41 061
Replacing vane pump for power steering
(4WD)
Caution!
Make sure all parts are absolutely clean.
No dirt is allowed to enter the system.
Seal off pipe connections with plugs.
Recycling:
Observe country-specific waste-disposal regulations.
Draw hydraulic fluid out of tank -> do not reuse.
Installation:
Fill hydraulic system.
Remove underbody protection at front and middle.
Remove drive belt.
Remove cooling air duct for brake on left and right.
Remove stabilizer bar from front axle support.
Disconnect pressure and suction lines from vane pump.
Installation:
Tightening torque, 32 41 3AZ.
RA Replacing vane pump for power steering (4WD)
BMW AG - TIS
16.02.2013 11:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -