3 Series E46 330xi (M54) SAL
Remove ITS head airbag from front grab handle bracket from
below.
Important!
Do not damage the ITS head airbag in the process!
Installation:
Pay attention to correct position of ITS head airbag in bracket
of front grab handle.
Retaining clip (2) of front grab handle retainer (1) must be above
ITS head airbag (3).
Important!
The retaining clip (2) must not have any sharp edges in the
area of the ITS head airbag!
Danger of damage to the ITS head airbag!
Replace bracket for front grab handle if necessary.
Unscrew bolt (1).
Push retainer, A-pillar, rear, towards top (2).
Remove retainer, A-pillar, rear, towards front (3).
Installation:
Tightening torque,
refer to Technical Data 72 12 3AZ
During installation, ensure that retaining lug is correctly seated
in body.
View of retainer, A-pillar, rear
1.
Retaining bore for retaining lug of retainer, A-pillar, rear in
body
2.
Retaining lug on retainer, A-pillar, rear,
must engage in mounting hole
3.
Retainer, A-pillar, rear
4.
ITS head airbag
RA Removing and installing / replacing left or right ITS head airbag (model without
BMW AG - TIS
16.02.2013 20:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 16 -