3 Series E46 M3 CSL (S54) COUPE
Then crank engine again in direction of rotation until 1st cylinder is
at TDC firing position.
Secure vibration damper in position with special tool 11 2 300 .
Check camshaft setting:
Attach special tool 11 9 140 and join in inlet camshaft.
Note:
The inlet camshaft is correctly adjusted when special tool
11 9 140 rests flat on the cylinder head or protrudes by max. 0.5
mm to the exhaust side.
If the special tool 11 9 140 protrudes to the inlet side, the
timing must be readjusted.
Join special tool 11 9 140 in exhaust camshaft.
Note:
The exhaust camshaft is correctly adjusted when special tool
11 9 140 rests flat on the cylinder head or protrudes by max. 0.5
mm to the exhaust side.
If the special tool 11 9 140 protrudes to the inlet side, the
timing must be readjusted.
If necessary, adjust camshaft timing.
Note:
Check installed direction.
Install holder (4).
RA Replacing camshafts (S54)
BMW AG - TIS
16.02.2013 15:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 28 -