3 Series E46 M3 (S54) CONVER
Installation:
Note position of dowel sleeves.
Replace damaged dowel sleeves.
Ensure correct position of cover plate.
Installation:
Remove release unit and release lever, clean and apply
grease to relevant points.
Installation:
Check lubrication of transmission input shaft for sticky
consistency. If grease is sticky, replace clutch plate.
Check clutch plate for friction rust in taper splines and replace
if necessary.
Mechanically remove old grease and lining abrasion from the
taper splines of the clutch disc (with a cloth).
Then apply a thin and even coat of grease with a brush in
entire area of taper splines. Also in taper groove and on guide
pin.
RA Removing and installing transmission (S6S 420G)
BMW AG - TIS
16.02.2013 11:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -