3 Series E46 M3 (S54) COUPE
Slacken nut (1).
Swivel ITS head airbag gas generator to one side (2) and remove
towards rear (3).
Installation:
Replace self-locking nut.
Tightening torque, 72 12 6AZ
Installation:
The two locating lugs (1) on the ITS head airbag gas
generator must be secured in the two bores in the support
tube for instrument panel (2).
Installation:
During installation, the ITS head airbag gas generator does not
rest flush on the support tube for instrument panel; there is an
intentional gap (A).
Tightening the self-locking nut builds up a desired pretension,
which servers as additional security against release.
Note:
If a gas generator of version up to 09 / 99 is replaced by a gas
generator from 09 / 99, it will be necessary to modify the
support tube for instrument panel.
RA Removing and installing / replacing left or right ITS head airbag (model without
BMW AG - TIS
17.02.2013 02:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
