3 Series E90 316i (N43) SAL
Release screws (1).
Tightening torque: 11 41 1AZ
.
Rotate suction tube (1) of oil pump downwards and twist out.
Installation:
Replace sealing ring on suction tube (1).
Position special tool 11 8 700 on balancing shafts (1).
Open plug (1).
Installation:
Replace seal.
Tightening torque: 11 11 8AZ
.
Note:
Picture shows N46T.
RA Removing and installing/replacing chain tensioner for oil pump drive (N43B16)
BMW AG - TIS
17.01.2013 10:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -