3 Series E90 318d (N47) SAL
Unscrew nuts (1).
Installation:
Tightening torque 34 51 6AZ
.
Important!
If necessary, release brake lines from holder on bulkhead.
Brake lines must not be bent!
Tilt out hydraulic unit (1) in direction of side panel.
When replacing hydraulic unit:
Release screws (1) and convert holder (2).
Installation:
Tightening torque 34 51 5AZ
.
Modify DSC control unit.
When replacing control unit:
-
Carry out programming/coding
-
Adjustment of steering angle sensor
-
Mix-up check of brake lines
RA Removing and installing or replacing DSC hydraulic unit
BMW AG - TIS
20.01.2013 11:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -