3 Series E90 318i (N46T) SAL
Replace cylinder head gasket.
Put the cylinder head on.
Fit new cylinder head screws.
Apply a light coat of oil to washer contact area and thread of new
cylinder head bolts.
Note:
Cylinder head bolts 1 to 6 have an M10 thread with an
E12 bolt head.
Cylinder head bolts 7 to 10 have an M9 thread with an
E10 bolt head. Cylinder head bolt 10 is shorter than the others.
Because of the unfavourable position of the exhaust camshaft,
cylinder head bolt 10 is only accessible with an E10 socket with
1/4" drive.
Tighten down cylinder head bolts in sequence 1 to 10.
Tightening torque 11 12 1AZ
.
Insert screws (1) and tighten down screw connection between
engine block and cylinder head.
Replace sealing ring.
Insert screw plug (1).
Tightening torque: 11 31 7AZ
.
RA Removing and installing/sealing cylinder head (N46T)
BMW AG - TIS
22.01.2013 13:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -