3 Series E90 318i (N46T) SAL
Note:
Clean rear window in assembly area thoroughly with spirit.
There must be no remnants of butyl on the rear window.
When replacing without removing rear window:
To be able to remove butyl remnants better, insert special tool
00 9 340 under tension between body flange and rear window.
To do so, wrap a cleaning cloth soaked in spirit around special
tool 00 9 340 several time and remove butyl remnants between
body flange and rear window.
Replacement of rubber frame with removed or new rear window:
Pay attention to centre marking (1) on rubber frame (3) and rear
window.
Place rubber frame (3) over centre marking on rear window and
align laterally.
Starting from centre, press down rubber frame (3) with firm
thumb pressure onto rear window over full length.
2
Marking with adhesive tape (if necessary)
4
Stainless steel section inlay
5
Butyl
Replacement of rubber frame without rear window removal:
Note:
Rubber frame is secured at side with window glass adhesive.
Read and comply with notes and instructions on handling window
glass adhesive.
Cut nozzle (4) at an angle in accordance with measurement (A).
A= 10 mm
Apply adhesive bead (1) on left and right of rubber frame (2) up
to fold (3) between rear window and body.
Note:
Adhesive bead (1) must not protrude over rear window.
If adhesive has managed to get onto bridge (6), this area must be
cut out partially.
Mark centre marking of rear window with adhesive tape on rear
window.
Mark centre marking (1) of rubber frame (3) with adhesive
tape (2).
Place rubber frame (3) over centre markings on rear window and
align laterally.
Starting from centre, press down rubber frame (3) with firm
thumb pressure onto rear window over full length.
RA Replacing rubber frame (bottom) for rear window
BMW AG - TIS
22.01.2013 17:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
