3 Series E90 320d (M47T2) SAL
Insert inlet camshaft.
Position (1) of inlet camshaft gear flush with cylinder head.
Position (2) of exhaust camshaft gear flush with cylinder head.
If necessary resecure secure camshafts.
Marking (1) on inlet camshaft must be between markings (2) on
exhaust camshaft.
See illustration.
The inlet camshaft bearing covers are marked E 1 ... E 5 from
the exhaust side.
Fit bearing covers.
Note:
Illustrations show M47TU.
Insert all screws (1) and initially tighten so that they are free of
play.
Tighten down inlet camshaft bearing caps in 1/2 turn increments
evenly from inside to outside.
Note:
Illustrations show M47TU.
RA Removing and installing/replacing inlet camshaft (M47T2)
BMW AG - TIS
23.01.2013 07:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -